Car Black Box Vision Drive VD-1600HD

Home > Product > VisionDrive_VD1600HD

Features

Spec.

Install

Usage

Caution

Installation Precautions

For safe installation and operation, carefully read all the information stated below.

DO NOT disconnect the power supply while the system is booting up for start or update.
Please keep it in mine that the product can be off for a short period of time during start-up.

- It is recommended to use only authorized SD cards provided with the VisionDrive® product.
- Only install the product after parking the vehicle in a bright and safe area.

- Make sure that you start installation with the power source completely turned off. The power connection should be the last step of the installation.

- Use the power cable provided with the product for the cigarette lighter power connection in the range of DC12V to DC24V. If power wiring is involved, we recommend a professional service for the installation.

- Prior to the installation, clean the area of the installation where the camera will be positioned.

- DO NOT eject the SD card when the product is in operation or when starting/booting up.

- DO NOT attempt to disassemble, modify or repair the product yourself in any way.

Installation Procedure

1) Assemble the bracket with the main body

- Place the bracket inside the groove of the unit then turn the bracket to click on.
(To remove the unit from the bracket, turn the unit in the opposite direction.)

2) Insert the microSD card into the unit

- Insert the microSD card as shown in the picture.
- When ejecting the microSD card from the unit, turn off the main power. When ejecting the microSD card from the unit, turn off the main power completely, and then push in the microSD card. The microSD card will pop out when pushed in.
Use of force or other methods to eject the microSD card may defect the microSD card.

3) Connect the cable and attach on windshield

- Clean the area on the windshield where the unit will be installed.
- For the placement of the unit, it is better to place the unit closer to the center of the vehicle. If the unit is installed on the right side of the back mirror, make sure there is room to detach the unit if needed.
- The adhesive on the bracket is very strong. Partially remove the cover of the adhesive, and then use the full adhesive surface area for final installation.

4) Connect to power source to turn on the product

- Insert the cigarette lighter power adapter into an appropriate outlet. If you start up the car or place the car key to ACC, the product start booting up with voice announcement.
- Blinking of LED lamps notifies that the system booting has succeeded.
- DO NOT turn off the power source while the system start-up is in progress as this may cause damage on product.
If power wiring is involved, we recommend a professional service for the installation.

5) Adjust the camera angle

- Move the camera top to bottom to fix it to the best position.

- For better images and operation of the dedicated analyzer, ensure that over 1/2 of the vehicle hood area is included in the recorded data.

- When the unit is installed, set the camera lens to face the front direction of the vehicle.

- Camera is adjustable and can be rotated 90 degrees to cover desired recording areas.

6) Check LED lamps

- The REC lamp is blue when it is recording (NORMAL) files and red when recording an (EVENT) file after an impact or if the SHOT button has been pressed.
- The GPS lamp is red when the GPS signal is not received then blue when it is received.
- It may take a couple of seconds to several minutes to get the GPS signal depending on the location of your vehicle.

7) Connect the optional camera

- When the optional camera is connected to CAM IN port the system reboots automatically to optimize the system for 2channel recording.
- Product reboots when the optional camera is connected to the product when it is on.

8) Arrange wires using wire holders

- Use the enclosed cable holders to organize cables.